600128CBL -
Encoder, 30 mA, 5 VDC (Nom.), 10 Kilohms (Pull-up), -40 to 65 degC, Optical
聲明：圖片僅供參考，請以實物為準！
- 制造商產品編號：
- 600128CBL
- 倉庫庫存編號：
- 70152977
由于產品數據庫龐大，部分產品信息可能未能及時更新，下單前請與銷售人員確認好實時在庫數量，謝謝合作！
600128CBL產品概述
600 Series Encoder, 30 Ma Current Rating, 5 VDC (Nom.) Voltage Rating
The series 600 controls are manually operated, rotary, optical encoders that output two square waves in quadrature at a rate of 128 pulses per channel per revolution as a standard with other resolutions down to 60 pulses available. The outputs are TTL compatible. The variation in this series is in the terminal configuration: either pin leads or cable leads.
Specifications. Input Power: 5 volts DC ±5% @ 30 MA max. plus external requirements. Output Rate 128 pulses/revolution per channel-standard; Other pulses/revolution between 60 and 128 are available. Channels: Two separate output channels in quadrature, 90° ±45°. Output Voltage: High level voltage — 2.4 volts min. with 10 KΩ load to ground; Low level voltage — 0.4 volt max. Operating Temp: -20°C to +65°. Vibration: 10 to 2000 Hz, 15 G peck; MIL-STD-202 method 204 test C. Shock: 100 G @ 6 ms MIL-STD-202 method 213 condition 1.
Mechanical Characteristics. Shaft Rotation: Continuous in either direction. Operating Speed: 300 rpm max. Rotational Life: 10 million revolutions. Rotational Torque: 1.5 ozs. in max. Shaft: 1/4 diameter standard, stainless steel. Bushing: 3/8 diameter standard, brass, nickel plated. Terminals: P/C Type — 0.25 by 0.12 thick brass, gold plated to facilitate soldering. Cable Type — Four lead ribbon cables, color-coded, with 0.050 spacing, 28 AWG stranded copper wire, 0.39 diameter. Strength: Terminals withstand 2 Lbs. push and pull and a 90° bend. Mounting Hardware (not supplied): For 3/8 bushing, use hex mounting nut 3/8 × 32 thread, 1/2 across flats, 3/32 thick; internal tooth lockwasher 11/16 O.D. by 0.022 thick. Seals: Mounting seal and shaft seal available. Controls are not sealed for board washing. Weight: P/C type or cable type. 1 in. FMS shaft and 3/8 bushing-0.046 Lb. (21 G). Loc. Pin (Not Standard): Single pin located 17/32 from center can be supplied.
Optical Incremental EncodersAnalog to Digital ConvertersTTL Compatible All ModelsOnly 1.125" Diameter × 0.484" Deep
Datasheet
