FLUKE-789產(chǎn)品概述
Double your power.
The Fluke 787 ProcessMeter was the first tool to combine a loop calibrato with a DMM to give process technicians
double the power in one tool. Now it’s even better – the ultimate loop calibration multimeter – the Fluke 789 ProcessMeter. The 789 has a display that’s not only twice as large, but also twice as bright with two levels of backlighting. And with its built-in, selectable 250 ohm HART? resistor, it eliminates the need to carry a separate resistor with you. Now process technicians can do a lot more while carrying a lot less.
Features:
24 V Loop power supply
HART mode setting with loop power (adds 250 ohm resistor)
100 % larger dual display
1200 ohm drive capability on mA source
Enhanced backlight with two brightness settings
0-100 % mA Span Check buttons to toggle between 4 and 20 mA
Infrared I/O serial port compatible with FlukeView? Forms Software Version 2.1 (available Feb. 2003)
Externally accessible fuses for easy replacement
DMM designed to meet 1000 volt IEC 1010 CAT III standards
Precision 1000 V, 440 mA True-rms digital multimeter
Frequency measurement to 20 kHz
Min/Max/Average/Hold/Relative modes
Diode Test and Continuity Beeper
Simultaneous mA and % of scale readout
20 mA dc current source / loop calibrator / simulator
Manual Step (100 %, 25 %, Coarse, Fine) plus Auto Step and Auto Ramp
Externally accessible battery for easy battery changes
Datasheet
