DLP-2232M-G - 

The DLP-2232M-G utilizes FTDI's third-generation USB UART/FIFO I.C., the FT2232D. This low-cost development tool features two Multi-Purpose UART/FIFO
controllers that can be configured individually in several different modes. In addition to the UART interface, FIFO interface, and Bit-Bang IO modes of the second-generation FT232BM and FT245BM devices, the FT2232D offers a variety of additional modes of operation including a Multi-Protocol Synchronous Serial Engine interface designed specifically for synchronous serial protocols such as JTAG and SPI bus.

Features:

Single board, USB Dual Channel Serial/Parallel Ports with a variety of configurations

Entire USB protocol handled on-board. No USB-specific firmware programming required

DLP-USB232M-style UART interface option with full Handshaking and Modem interface signals

UART Interface supports 7/8 bit data, 1/2 stop bits, and Odd/Even/Mark/Space/No Parity

Transfer Data Rate 300 to 1 Mega Baud (RS232)

Transfer Data Rate 300 to 3 Mega Baud (TTL and RS422 / RS485)

Auto Transmit Enable control for RS485 serial applications using TXDEN pin

DLP-USB245M-style FIFO interface option with bi-directional data bus and simple 4-wire handshake interface

Transfer Data Rate up to 1 MegaByte/Second

Enhanced Bit-Bang Mode interface option

New Synchronous Bit-Bang Mode interface option

New CPU-Style FIFO Interface Mode option

New Multi-Protocol Synchronous Serial Engine (MPSSE) interface option

New MCU Host Bus Emulation Mode option

New Fast Opto-Isolated Serial Interface Mode option